Montierbare Klemmringe: Schnellspann
Quick clamping mountable shaft collars combine a standard collar with outer diameter (OD) flats and holes and adjustable clamping handle. This creates a mountable shaft collar than can be rapidly adjusted without the use of tools. Quick clamping mountable shaft collars are well suited for sensor systems or welding applications where frequent adjustment is required. The shaft collar is manufactured by Ruland with tightly controlled face to bore perpendicularity (TIR ≤ .002" or 0.05mm) which is critical when the shaft collar is used as a load-bearing face, mechanical stop, or for aligning components on a shaft. The tapped holes in the OD fit standard cap, torx, or set screws allowing the designer to use hardware of their choosing to match application requirements. Mountable shaft collars with OD holes are available in 1215 lead-free steel for the greatest holding power, 2024 high-strength aluminum for light weight, and 303 stainless steel for corrosion resistance. Bore sizes range from 1/2” to 1-1/2” and 12mm to 40mm. The adjustable clamping handle is sourced from JW Winco and is zinc die cast with a powder coated finish. They are available in black for general purpose use and orange for safety and identification.