Dimensions | |||
---|---|---|---|
Bore B |
0.313 in |
Bore Tolerance |
+.001 in / -.000 in |
B1 Shaft Penetration |
0.467 in |
Outer Diameter OD |
1.000 in |
Length L |
1.125 in |
Hub Width LH |
0.467 in |
Fastening Hardware | |||
Forged Set Screw |
M4 |
Number of Screws |
2 ea 90° apart |
Screw Material |
Alloy Steel |
Screw Finish |
Black Oxide |
Seating Torque |
2.2 Nm |
Hex Wrench Size |
2.0 mm |
Performance Specifications | |||
Angular Misalignment |
0.5° |
Parallel Misalignment |
0.008 in, 0.20 mm |
Max Parallel Misalignment |
0.100 in, 2.54 mm |
Axial Motion |
0.004 in, 0.10 mm |
Maximum Speed |
4,500 RPM |
||
Additional Information | |||
UPC |
63452906211 |
Country of Origin |
USA |
Material Specification |
2024-T351 Aluminum Bar |
Finish |
Black Anodized |
Finish Specification |
Sulfuric Anodized MIL-A-8625 Type II, Class 2 and ASTM B580 Type B Black Anodize |
Manufacturer |
Ruland Manufacturing |
Temperature |
Acetal Disk -10°F to 150°F |
Weight (lbs.) |
0.0720 |
Product Notes | |||
Note 1 |
Stainless steel hubs are available upon request. |
Note 2 |
Performance ratings are for guidance only. The user must determine suitability for a particular application. |
Note 3 |
Torque ratings for the couplings are based on the physical limitations/failure point of the torque disks. Under normal/typical conditions the hubs are capable of holding up to the rated torque of the disks. In some cases, especially when the smallest standard bores are used or where shafts are undersized, slippage on the shaft is possible below the rated torque of the disks. Keyways are available to provide additional torque capacity in the shaft/hub connection when required. Please consult technical support for more assistance. |
Prop 65 |
|