Dimensions | |||
---|---|---|---|
Large Bore B1 |
0.625 in |
Small Bore B2 |
14 mm |
B1 Shaft Penetration |
0.874 in, 22.2 mm |
B2 Shaft Penetration |
0.874 in, 22.2 mm |
Outer Diameter OD |
2.000 in, 50.8 mm |
Bore Tolerance |
+.001 in / -.000 , +.03 mm / -.00 mm |
Length L |
1.813 in / 46.1 mm |
Hub Width LH |
0.810 in, 20.6 mm |
Fastening Hardware | |||
Forged Clamp Screw |
M5 |
Screw Material |
Alloy Steel |
Hex Wrench Size |
4.0 mm |
Screw Finish |
Black Oxide |
Seating Torque |
9.5 Nm |
Number of Screws |
2 ea |
Performance Specifications | |||
Static Torque |
350 lb-in, 39.6 Nm |
Angular Misalignment |
1.0° |
Dynamic Torque Non-Reversing |
175 lb-in, 19.80 Nm |
Parallel Misalignment |
0.00 in, 0.00 mm |
Dynamic Torque Reversing |
87.5 lb-in, 9.90 Nm |
Axial Motion |
0.012 in, 0.30 mm |
Torsional Stiffness |
867 lb-in/Deg, 98.0 Nm/Deg |
Maximum Speed |
10,000 RPM |
Additional Information | |||
Material Specification |
Hubs: 2024-T351 Aluminum Bar, Disc Springs: Type 302 Stainless Steel |
Temperature |
-10°F to 200°F |
Finish Specification |
Sulfuric Anodized MIL-A-8625 Type II, Class 2 and ASTM B580 Type B Black Anodize |
Manufacturer |
Ruland Manufacturing |
Country of Origin |
USA |
Weight (lbs.) |
0.4400 |
UPC |
63452913249 |
||
Product Notes | |||
Note 1 |
Stainless steel hubs are available upon request. |
Note 2 |
Torque ratings are at maximum misalignment. |
Note 3 |
Performance ratings are for guidance only. The user must determine suitability for a particular application. |
Note 4 |
Torque ratings for the couplings are based on the physical limitations/failure point of the disc springs. Under normal/typical conditions the hubs are capable of holding up to the rated torque of the disc springs. In some cases, especially when the smallest standard bores are used or where shafts are undersized, slippage on the shaft is possible below the rated torque of the disc springs. Keyways are available to provide additional torque capacity in the shaft/hub connection when required. Please consult technical support for more assistance. |
Prop 65 |
|